DP series pressure rod discharge dust collector

DP series—Press bar discharge type industrial dust collector

       DX series products are characterized by automatic unloading, large air volume, and pulse back blowing ash cleaning. They adopt an integrated cabinet structure and beautiful appearance. They are specially designed for powder industry, chemical industry, metal processing industry, woodworking furniture industry, etc. Designed to achieve 24 hours of continuous work without downtime and high cost performance. Equipped with Siemens motor and Japanese Toray polyester fiber filter cartridge to ensure high-level filtration accuracy and efficiency.

♦ Siemens motor, continuous escort

           In terms of power system, the three-phase 380V voltage adopts Siemens three-phase asynchronous motors, equipped with special custom aluminum alloy impellers, the perfect combination of negative pressure and flow, stable operation, low failure rate, low noise, and can work continuously for 24 hours.

♦ Cartridge filter, high filtration accuracy

           For the filtration system, a cartridge filter is used, and the Japanese Toray polyester fiber substrate is used. Standard configuration of polyester fiber oil-proof and water-proof material, the filter accuracy of dust with an equivalent diameter of 3 micrometers or more is more than 99%, and a filter cartridge material with higher filtering accuracy can be selected.

♦ Specially set dust cleaning door, no secondary pollution

           The pneumatic pulse blowback system consists of a cylinder, an electromagnetic pulse valve, a PLC controller, and compressed air. One end of the pulse valve is connected to a compressed air storage cylinder and the other end is connected to an injection pipe. An exhaust valve is installed on the valve cover, and the exhaust valve is controlled by a pulse controller.

           When there is no signal from the pulse controller, the pulse solenoid valve starts to work, and each time the ash cleaning is completed at about 0.1 to 0.3S, it is the high-pressure air that is sprayed at this instant to play a good ash cleaning effect. Air enters the filter cartridge at a high flow rate, causing the filter cartridge to expand rapidly, causing an impact vibration, causing the dust attached to the filter cartridge to be shaken off, and the fine dust adsorbed on the surface of the filter material is shaken into the dust collecting bucket under the action of the airflow .

♦ Electric control system, quality assurance

            In terms of electrical systems, the main electronic control components are from internationally renowned brands-French Schneider products. The motor realizes independent control of the electrical box, built-in power sequence switch, thermal overload protection, phase loss, reverse phase and other phase sequence protection. The control panel is simple and generous, which can easily realize remote control, linkage control and other functions.

♦ Press bar discharge structure, practical and convenient

            The stainless steel dust bucket uses a pressure bar type discharge structure. When the dust is full, lift the pressure bar to remove the dust bucket and pull it out to clean up the dust. After the dust bucket is completed, you can send it in. Convenient, fast and practical.

♦ Industrial non-slip casters, top polyurethane material

            Industrial mobile casters are standard accessories for this machine. The wheels are made of top-grade polyurethane (PU), and the bracket uses 2.5mm pickling plates to increase the reinforcement. Each 4 inch caster can carry 150kg.

♦ Customized suction port, according to your needs